ejs

BIC-104B
BIC-104B
Description
With this module you will be able to turn on car's park heater with original remote control. Module works on BMW E38/E39/E53 models.

Price
45 EUR

How to use (video)
  1. Press Lock button on a remote control. It is not important if the car is locked or  unlocked at the moment.
  2. Wait for turn lights blink.
  3. Press Lock button again.
  4. Wait for turn lights blink.
  5. Press Lock button again.
  6. Wait for turn lights blink.
  7. Module will start park heater at this time.
  8. If heater is started successfully, turn lights will blink 3 times. If there was no turn lights blinking or there is one long blink (this means that heater has not started), repeat everything from beginning.

  9. Park heating will turn off after 30 minutes of operation, or whenever ignition is turned on.
Requirements
  1. Heater unit must be in a working condition, also park heating option must be enabled. When park heating is operating, it must heat up engine and passenger compartment.
  2. There must be a good battery must be installed in a vehicle. Park heater will not work it battery is in a bad condition (f. e. discharged).
  3. Controller will work only in BMW E38/E39/E53 models.

Technical information
  • Controller connection example diagram is located here.
  • Controller must be connected to the vehicle’s K-bus.
  • Controller must be supplied with constant power supply (terminal 30).
  • Controller is not water resistant. It should be installed inside vehicle passenger compartment. It is recommended to install unit behind IHKA climate control module or near the GM/ZKE general module behind glovebox.
  • Unit can be installed into vehicles without MID controller or without On-Board Monitor. In that case, park heating option should be coded/enabled only in IHKA climate control module.
  • Vehicles alarm system's tilt and passenger compartment sensors are deactivated after heating activation. That is because controller uses the same remote control keypress sequence as it is used for alarm system sensors deactivation. To activate these sensors vehicle must be unlocked and locked again.

Installation instructions for BMW E38/E39 model
It is recommended to install ejs BIC-104B module near the GM (general module) control unit.
The fuse included in package can be left unused this time.
Remove trim panel behind glovebox by pulling it backwards.
Find a 26 pin white connector on the GM unit. Connect following BIC-104B wires to wires of this connector:

  1. Red to Red/Green (pin 1);
  2. Brown to Brown/Black (pin 14).
  3. Yellow to White/Red/Yellow (pin 12).
Installation instructions for BMW E53 model
It is recommended to install ejs BIC-104B module behind the IHKA climate control unit.
The fuse included in package can be left unused this time.
Remove IHKA climate control unit.
Find a 3 wire connector (the bigger one) on the IHKA unit. Connect following BIC-104B wires to wires of this connector:
  1. Red to Red/Violet (pin 1);
  2. Brown to Brown (pin 3).
Then find a 26 pin blue connector on the IHKA unit. Connect following BIC-104B wire to wire of this connector:
  1. Yellow to White/Red/Yellow (pin 3).
Downloads
Wiring diagram

Warranty
One-year limited warranty applies to this product. Manufacturer and supplier do not apply warranty to the park heater and do not take responsibility for the park heater.

Shipping and payment

Contacts
E-mail: justas@autodarna.lt




PRADŽIA
PASLAUGOS
KONTAKTAI
APIE ĮMONĘ
ATSILIEPIMAI
GALERIJA
DUK
ejs