ejs

BIC-104W
BIC-104W
Description
K-bus controlled Webasto park/auxiliary heater activation module with single input for constant positive signal.
This controller enables to turn on BMW K-bus controlled Webasto park/auxiliary heater by applying +12V to the controller.

Price
45 EUR

Requirements
  1. Module is able to operate only K-bus controlled Webasto auxiliary heaters, that can be found only in BMW E39/E39/E53/E46 vehicles. For full list of supported heaters click here.
How to use
  • Heater is activated by supplying positive (10V - 15V) signal to controllers input pin. Therefore switch, timer, car alarm system or other electronics devices could be used for heater activation.
  • Heater is turned off automatically after 30 minutes of operation, or when positive signal at the input is switched off. Turn off time can be set to any value or deactivated on demand.
Technical information
  • Controller connection example diagram is located here.
  • Controller must be connected to the heater's K-bus pin 2.
  • Controller must be supplied with constant power supply (terminal 30). Power supply wire must be fused with a 2A fuse.
  • Controller is not water resistant. It should be installed inside vehicle passenger compartment.
Downloads
Wiring diagram

Warranty
One-year limited warranty applies to this product. Manufacturer and supplier do not apply warranty to the park heater and do not take responsibility for the park heater.

Shipping and payment

Contacts
E-mail: justas@autodarna.lt

PRADŽIA
PASLAUGOS
KONTAKTAI
APIE ĮMONĘ
ATSILIEPIMAI
GALERIJA
DUK
ejs